Stubborn weeds like sedges and broadleaves are the bane of any lawn lover’s existence. If you’ve tried numerous spot treatments and cultural practices to no avail, then Recognition herbicide could prove your silver bullet. This popular post-emergent product is formulated to safely control over 40 common grassy and broad-leaved weeds in turf like Bermuda, zoysia, and St. Augustine grasses.
While Recognition has a rock-solid reputation for handling tough weeds, applying it well takes some know-how. This guide will walk you through 5 foolproof methods for getting the most out of your herbicide.
First, Read the Fine Print
Before diving into application techniques, it’s important to stress that carefully following the product label is absolutely necessary for Recognition to work its magic. The label contains critical info on rates, grass tolerances, and weather restrictions.
1 – Broadcast Spraying for Large Areas
Broadcast spraying is a go-to for treating broad weed infestations across sizable lawn sections. Simply mix Recognition according to the label and spray uniformly using a pump-up or backpack sprayer.
For large jobs, a lawn tractor sprayer comes in handy. The key is to walk steadily, keeping the nozzle tip about 3 feet above the grass. Overlap spray patterns for consistent coverage. Broadcasting lets you efficiently knock out weeds en masse when time is short.
2 – Spot Spraying Recognition Herbicide for Scattered Weeds
If weeds are scattered here and there rather than taking over, targeted spot spraying may save you time versus a full broadcast. Fill a small pump sprayer and precisely spray just the foliage of individual weeds and a few inches of surrounding grass.
Squirt each weed area until just damp, taking care not to over-apply. Spot spraying minimizes herbicide use while still zapping troublesome weeds fast.
3 – Wiping Tall, Emerging Weeds
Sometimes, weeds get a few inches tall before you notice. For sensitive grasses, wiping rather than spraying the herbicide on plants over 2 inches high is best.
Saturate a cloth or paper towel with the herbicide mixture. Then, wipe the leaves of unwanted weeds while avoiding getting any of the mixture onto the grass.
Wiping deposits less chemical onto the fragile turf blades below. Taller weeds usually need a follow-up treatment for full control.
4 – Watering In for Best Uptake
Most yards receive precipitation soon after applying Recognition, allowing the herbicide to internalize through weed leaves. But during prolonged dry spells, it’s a good idea to thoroughly water-in after 30 minutes have passed.
5 – Re-treatment for Stubborn Cases
Even if applied perfectly, some weeds may need an extra dose of Recognition herbicide to reach termination. If following up two weeks post-treatment reveals living foliage, don’t pull your hair out – spray again.
The second application should do the trick, as stubborn weeds will have absorbed more active ingredients over time. Always check the label for re-treatment intervals if needed. Consistency is key to winning the war on weeds.
In Conclusion
With a little practice, you’ll easily use these application methods to keep your lawn weed-free. Just remember that Recognition controls various weeds without harming your warm-season turf. Understand exactly how to deploy this versatile post-emergent product to the best effect, and you’ll wake up to a thick, lush carpet of green every morning!
